Pump installation method:
- 1. Connect the water pump and the water pipe and connect them together;
- 2. adjust the pump switch size to the appropriate location.It is recommended to adjust to the "+" position
- 3. Place the connected water pipes and pumps in the right place for the product
- 4. Pump flat, and then add water to completely submerged water pump, plug in the power can be normal operation.
- Pumps must be placed in the water will work properly, the pump is waterproof design;
- The battery in the water surface must exceed the maximum height of the pump at least 1-2 cm, can extend the pump life;
- if the water is not large, please check the pump on the water switch is open to the maximum;
- as long as 3-5 days for a water, half a month to clean the pump, you can extend the life of the pump.
- Powering on before submerged in water can damage the product.
- Do not touch the nebulizer during operation.Please turn off the power of the nebulizer before touching it.
- Please turn off the power when not in use to extend the service life.
- The atomizer will produce water mist. When the water mist hits the table, water may form. This is a normal physical phenomenon called condensation. If you see water on the table, not a product damage leaking, just the temperature of the table top is lower than the water mist, causing the water mist to turn into water. Just put a small towel under the product to solve it.